Page 1 of 1

White stains on silver after ultrasonic

Posted: Thu Jan 11, 2018 4:56 am
by EMJ
Hi everyone,

I have a small sterling silver jewelry production line and I've been encountering a problem with the ultrasonic.
After I use the ultrasonic to clean the pieces I would find sometimes some white haze on the pieces that wouldn't go off without polishing again. This happens for the most part with flat designs but can happen with others as well but will be less visible.
I use an ultrasonic machine with the water aimed at 80 degrees C and use an ultrasonic compound in the water to clean it even further.

I tried to change through a few compounds in order to see if that was the reason and so far all of them presented the same problem.

Is anyone else encountering the same problem or found a solution to minimize it from happening?

Re: White stains on silver after ultrasonic

Posted: Thu Jul 26, 2018 8:05 pm
by silverhammer

Are you using the ultrasonic to remove polishing compound?