Early patch box :repair or leave as it is?

Do not post mark questions here.
drlaser12
Posts: 8
Joined: Sat Feb 14, 2009 8:30 am
Location: Nijmegen Netherlands

Early patch box :repair or leave as it is?

Postby drlaser12 » Thu Feb 19, 2009 4:17 pm

This light gauge small patch box (2.5 cm in diameter x 1.3 cm in height) probably dates from around 1680 (see Eric Delieb's 'Silver Boxes'). There is an undecipherable maker's mark on the inside of both box and lid. The amorous message seems to reflect the condition of the box: it is more fine than strong.

The lid shows a split as a result of wear around part of the engraving. I can imagine that a very careful repair would improve the quality of the box or......should it rather be left as it is?

Thank you in advance,

Robbert.

Image

Image
.

dognose
Site Admin
Posts: 40553
Joined: Thu Dec 29, 2005 12:53 pm
Location: England

Postby dognose » Thu Feb 19, 2009 6:42 pm

Hi Robbert,

Just a personal opinion, but I would leave it as it is. I would only consider having it repaired if the section had, or was likely to become, detached.
Any repair, I think, hides a little bit of the original craftsmanship by the man that made your box.
I think you would lose more than you would gain.

Regards Trev.
.

georgiansilver
contributor
Posts: 415
Joined: Thu Jan 12, 2006 5:50 am
Location: Gainsborough, Lincs

Postby georgiansilver » Fri Feb 20, 2009 7:11 am

Any repair unless invisible would not add to the value of the box and unless you are going to use the box rather than keep it as part of a collection.. it is not worth the expense. Best wishes, Mike.
.

Doos
co-admin
Posts: 329
Joined: Tue Jul 26, 2005 6:06 am
Location: The Netherlands
Contact:

Postby Doos » Fri Feb 20, 2009 10:15 am

Hi,

I would leave it as is, but if you do decide on repairs, have it done by someone who knows what he is doing. Send me a personal message for the name of the right person.

Alain
.

buckler
moderator
Posts: 1064
Joined: Fri Apr 06, 2007 6:52 am
Location: England, Warwickshire

Postby buckler » Fri Feb 20, 2009 10:20 am

I agree with the two comments above. If an article is not going to deteriorate without repair, or be used, leave well alone. Currently it's in original condition. Even if you want to sell, leave the decision to the purchaser. Currently any repair will alter it - in thirty years time there may be micro welding techniques not available to us that may change views.
.

drlaser12
Posts: 8
Joined: Sat Feb 14, 2009 8:30 am
Location: Nijmegen Netherlands

Postby drlaser12 » Fri Feb 20, 2009 5:48 pm

Thank you Trev,Mike, Alain and Buckler for your most valuable advise.
I will leave this box just as it is .....and enjoy it!
.


Return to “General Questions”

Who is online

Users browsing this forum: No registered users and 3 guests